Powertool World Pixel Foam - Universal Pick & Pluck Foam Inlay Finally a universal customisable inlay solution for a massive range of carry cases. Our very own, manufactured in the UK, pick \'n\' pluck foam inserts are made out of high quality foam pieces to keep your valuable tools stored safe and secure in your carry case. Included is the main insert, a 50mm thick block of foam with pick \'n\' pluck pieces - surrounded by a thin border ready to customise to your requirement. Also included is a 10mm base layer so your tools never have to touch the plastic of the carry case base. Please note the carry case is not included. Tip: To \"pluck\" the foam out to your requirement, push the foam pixel to the base of the case and it should release from its surrounding. Tip: Use your removed pixels to bolster your base layer if you\'re housing a thin tool such as a rangefinder or an accessory. Tip: Remove the outer border before attempting to customise to your carry case for ease of fit FITTING Customise to fit a wide range of kitbox no bigger than 440mm x 340mm square including: Bosch L-BOXX T-LOC Systainer Metabo Metaloc FEATURES Exclusive to Powertool World, these foam inlays are designed to fit any case 440 x 340 mm square or smaller 50mm foam inlay with \"pick \'n\' pluck\" customisable centre Fits nearly every tool on the market that will fit in a 440 x 340 mm carry case Ideal for Bosch L-BOXX, T-LOC Systainer,Metabo Metaloc and more 2 piece set includes foam block and base layer SPECIFICATION Block Dimensions (to Edge): L: 470mm W: 360mm H: 50mm Base Dimensions (to Edge): L: 470mm W: 360mm H: 10mm Pixel Size: 20 x 20 mm