McNett Gear Aid Black Witch Neoprene Cement - 28g Tube The new McNett Gear Aid Black Witch “toluene free formula” Aquasure + Neo quick drying neoprene contact adhesive is suitable for quick, (up to one hour) repairs, of Neoprene rips and tears and especially suitable for Neoprene butt end jointing of seams or edges, where rubber is directly bonded together. McNett Gear Aid Black Witch is also suitable for use on latex wrist and neck seals etc.  Black Witch is a ready to use, solvent based contact adhesive perfect for excellent adhesion to neoprene, rubber and various types of flexible plastics and is therefore suitable for fast repairs to Neoprene wet suits and other water sports equipment. Due to its fast flash off and long open period, bonds may be made over a wide range of open times and the fast-cure time of approx. 1 to 2 hours is especially suitable for quick in-field repairs. After cure, Black Witch exhibits good flexibility and resistance against heat, weathering, ageing, moisture and UV light. – For further technical information please refer to the data sheet and instructions. Note: When quick repairs are not required, or to re-coat high wear abrasion areas such as knee or elbow sections etc, use McNett Gear Aid Aquasure high strength, permanent adhesive. Features: 28g tube of toluene free McNett Gear Aid Black Witch adhesive. Quick drying neoprene adhesive For use on neoprene, rubber, latex, vinyl and many other materials. Fast Acting – Dries in 20 minutes for fast in-field repairs to wetsuits, waders and more Durable – This tough adhesive bonds to neoprene, latex and rubber Flexible – Cures to an elastic rubber that stretches and bends with fabrics Abrasion resistant – Coat high-wear areas like knees and elbows to protect against abrasion Waterproof – Provides a water-tight seal to keep watersports gear performing no matter the activity Instructions for Neoprene Repairs: Full instructions inside card. Apply a thin even coat of Black Witch on both edges of the repair area. Allow to dry for 5 minutes or until ‘touch dry’ (i.e. adhesive is glossy and no longer transfers to the knuckles) Align the bond edges and bond under maximum pressure. (i.e. press and hold edges together)  If possible continue to maintain the jointed surfaces under pressure until Black Witch is cured in approximately one to two hours. Ensure surfaces are fully bonded before use. Note: The full technical cure period is approximately three days. In case of contact with hands wash using brush soap and water. Please refer to the data sheet for further information.