McNett Gear Aid Aquasure FD Urethane Repair Adhesive and Sealant - 28 Gram Tube Due to shipping restrictions this can only be purchased in store. Aquasure+FD Flexible and Durable Urethane Repair Adhesive and Sealant. High viscosity urethane gel. Ideal for applications where thick, durable applications are needed. Seal seams and bond thick materials or coat materials for abrasion resistance. Excellent potting compound, electrically non-conductive. Examples of Aquasure compatible materials: Neoprene, Hypalon, vinyls, natural and synthetic leather and suede, tri-laminate materials, foams, composites and many plastics. Aquasure+FD is the industry leading sealant and fast drying adhesive trusted by millions of divers worldwide. Toluene Free ingredients ensure that all safety standards are exceeded allowing personal use as and when required. Colour your glue: You can add colour to Aquasure FD using ceramic pigment found at most craft stores. Just mix it directly into the adhesive prior to application. Features: Flexible urethane repair adhesive and seam sealer Industry standard for maximum strength gear repairs Safe on natural and synthetic fabrics including GORE-TEX®, neoprene, Hypalon®, rubber and more Repairs rips, tears and holes in watersports and scuba gear Specifically formulated to offer superior flexibility as well as excellent adhesion, waterproofing and abrasion resistance with minimal shrinkage Washable and unaffected by extreme heat or cold Dries Clear Moisture cured Contents: 28g / 1oz Tube. Comes With Applicator Brush Packaging may vary Directions for Neoprene Repair: Clean damaged area with Cotol-240(TM) Cure Accelerator/Precleaner or solvent Trim loose threads. Non-fabric surfaces should be roughened with sandpaper, then cleaned. Apply Aquasure to surfaces directly from tube or with knife or flat stick. Keep repair level overnight. Avoid contact with other surfaces. Most repairs reach full strength overnight (10-14 hours). Allow longer for thickest repairs. For fastest cure (2 hours or less), mix in Cotol-240. HOLES AND TEARS: Create backing with removable tape. Fill void and 1/4\" beyond edge with McNett Aquasure. Remove tape after full cure. SEAMS: Apply 1/16\" thick bead overlapping seams edges by at least 1/4\". Apply with slight pressure to saturate fabric surfaces. HIGH WEAR AREAS: Apply thin coat with knife for flexible abrasion resistance.