The Trend KWJ700 KWJ700 Kitchen Worktop Jig, an all in one jig for joining worktops The Trend KWJ700 Kitchen Worktop Jig is a hard-wearing solid laminate, 12mm thick jig that cuts both parts of the joint in 15 minutes including setting up. Trade all in one jig for joining worktops up to 700mm wide with a router.  Features:   Pins made from ABS plastic for strength   Engraved markings for identification of pinholes  Engraved lines for short 65mm bolts and worktop cross-cut  Three open-ended bolt recesses (dog bone style) for 150mm bolts  Cuts up to 40mm thick worktops with or without anti-drip postformed edge  Fixed lengths for 250mm, 300mm, 400mm, 500mm, 550mm, 600mm, 616mm, 650mm and 700mm wide worktops  10mm diameter plastic pins with tapered shoulder for tight fit provides three-point pin contact to ensure ease of setting up  Left hand and right-hand corners, 400mm radius peninsular joint, 45-degree end cut with slight radius, 45-degree trade corner solution for hob units, 100mm radius corner, 40mm radius corner, 35mm kitchen door hole and 3/4inch BSP hole for mixer taps  9 Functions:   Male cut  Female cut 45° end cut  Curved peninsular  R40mm corner radius  45° mitre corner joint  Connector bolt recess R100mm corner radius  35mm circular hinge and 3/4\" BSP hole   Comes with:   6 x ABS Plastic Pins   Jig requires:   Two clamps   A template guide bush with 30mm outside diameter  A TCT router cutter with 12.7mm (1/2 inch) diameter and 50mm (2 inch) cut length  A portable plunge router with 12.7mm (1/2 inch) shank capacity and minimum 1300 watts  Specification:  Weight: 5.4 kg  Width: 390mm  Length: 985mm  Thickness: 12mm  End Cut: 45 degrees  Corner Radius: 40mm  Corner Radius: 400mm  Corner Radius: 100mm  Corner Mitre Joint: 45 degrees  Female cut material width loss: 35mm