2 4G 4CH Micro Low Voltage DSM2 DSMX Compatible Receiver Built in Brushed ESCDescription Item Name ReceiverChannel 4Input Voltage 3V 5 5VWeight 1 4gDimension 21 3x11 9x5 8mmConnector Size JST 1 0mmSocket Size 1 25mm 2PRecommended Parts for This receiver Not Included Servo 1 7g Servo with JST 1 0mm Plug Click HereBattery 1S 3 7V 100mAh LiPo Battery with 1 25mm 2P Plug Click HereFeatures Compatible with DSM2 DSMX transmitter Bulit in 2A brushed ESC supported external brushless ESC no need to program The receiver signal can stay stable even if the voltage is 2 5V Improve signal interruption problem when micro receiver using a conventional 1S brushless motor How To Bind 1 Insert the bind plug into the channel labeled BIND and power up the receiver 2 set the throttle and control surface failsafe protection recommended to set the throttle to a minimum all the control surface is set to the middle position Press and hold the bind button and turn on the remote control 3 the frequency of the receiver LED flashes will change from fast to slow A few seconds after the end of the binding the receiver s LED will always be on All failsafe protection settings are successful 4 Remove the bind plug from the BIND channel Re power the receiver and all channels are working properly To test the failsafe protection feature roll the lever to the corner and turn off the control The control surface and throttle will return to the original position where the failsafe w