FEATURES FURY KF316C10BB/8 is a 1G x 64-bit (8GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 512M x 8-bit FBGA components per module. Each module has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. Each 240-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows: CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh Command Time (tRFCmin) Row Active Time (tRASmin) FACTORY TIMING PARAMETERS • Default (Plug N Play): DDR3-1600 CL10-10-10 @ 1.5V  DDR3-1333 CL9-9-9 @ 1.5V  DDR3-1066 CL7-7-7 @ 1.5V • JEDEC standard 1.5V Power Supply • VDDQ = 1.5V • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write • Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1 ) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C • Asynchronous Reset • Height 1.338” (34mm) w/heatsink SKU KF316C10BB/8 EAN/UPC Code 740617318111 Brand Kingston Memory Capacity 8GB Module Quantity 1 Module Speed 1600MHz (PC3-12800) Error Check Non-ECC Model/Series/Type Fury Beast Module Type DIMM CAS Latency CL10 Form Factor DDR3 Rank 2R (Dual Rank) Warranty Lifetime Pins 240 Pin Colour Black Memory Voltage 1.5v Memory Depth 1G Product Condition New Product Type/Family RAM Packaging Type Retail Data Width X64 Chip Organization x8 Heat Spreader Yes